Performance Investigation of Different Hydro-cyclones in Sand Removal from Water Wells: A Laboratory Study

Document Type : review paper

Authors

• Ali dehnavi ¹
• Naser Adelpour ²
• Saied Mohammad Saeid Mosavi Sodagar ³

¹ University of Isfahan

² Isfahan High Education and Research Institute, Iran

³ Mashhad Water and Wastewater Company, Iran

https://doi.org/10.22067/jwsd.v3i2.53134

Abstract

This study investigates the amount of suspended solid particles in three drinking water wells, conducted several times per day in the city of Mashhad. The results have also been used for the review and optimization of tested hydro-cyclones. For this purpose, 18 different hydro-cyclones, based on the experimental design process of the Taguchi method, were designed and the affecting factors were investigated. These factors include inlet diameter, overflow diameter, apex diameter, body diameter of the hydro-cyclone, the cylindrical height, and the total height of the hydro-cyclone. For the optimization process, the maximum concentration observed within all samples from the Mashhad wells, equating to 100 mg per liter was used. The results of the laboratory study, for two repeats, showed that in optimum conditions, the mass removal efficiency of the suspended solids was up to 97.2 ± 1.1 percent. In these circumstances, the ratio of inlet and overflow diameter size to the hydro-cyclone diameter size was similar and equivalent to 0.225, and the apex diameter size ratio to the hydro-cyclone diameter size was 0.15. Also, the ratio of cylindrical and overflow height to the total height of the hydro-cyclone were 0.12 and 0.08 respectively.

Keywords

• Hydro-cyclone
• sand in water well
• sand separation from water
• Taguchi method

References

آذری، م.ص. 1375. ارزیابی عملکرد ژئوتکستایل در افزایش راندمان و جلوگیری از ماسه‌دهی چاه‌های آب. پایان‏نامه کارشناسی ارشد. دانشکده کشاورزی. دانشگاه تربیت مدرس. تهران.

پیکری، م. و مهربانی، ا. 1387. مبانی تصفیه آب. چاپ سوم. انتشارات ارکان دانش. اصفهان.

چالکش امیری، م. 1388. اصول تصفیه آب. چاپ هفتم. انتشارات ارکان دانش. اصفهان.

رحمانی، ع.ا. 1384. هیدروسیکلون‌ها. انتشارات سایه گستر. قزوین.

عباس‌نوین‌پور، ا. 1391. ارائه راهکارهای مناسب عملی برای حل مشکل ماسه ‏دهی چاه ‏ها ‬(مطالعه موردی: چاه ‏های دشت سلماس)‬. گزارش طرح تحقیقاتی. گروه زمین‏ شناسی. دانشکده علوم دانشگاه ارومیه. ارومیه.

APHA. 2005. Standard methods for the examination of water and wastewater. American Public Health Association (APHA). 21st Edition.

Arterburn R.A. 1982. The sizing and selection of hydrocyclones. Design and Installation of Comminution Circuits, 1: 597-607.

Coelho M.A.Z. and Medronho R.A. 2001. A model for performance prediction of hydrocyclones. Chemical Engineering Journal, 84(1): 7-14.

Environmental Services. 2010. Environmental Fact sheet: Sand and sediment in water supply wells. Technical report. New Hampshire Department Environmental Services. United States.

Hsu C.Y., Wu S.J. and Wu R.M. 2011. Particles Separation and Tracks in a Hydrocyclone. Tamkang Journal of Science and Engineering, 14(1): 65-70.

John Deere Water Company. 2014. F1000-Hydrocyclone Sand Separator. Technical report. (Available from http://www.powerplastics.com/downloads/F1000-Hydrocyclone-sand-separator_0811_5000.pdf)

Martinez L.F., Lavin A.G., Mahamud M.M. and Bueno J.L. 2008. Vortex finder optimum length in hydrocyclone separation. Chemical Engineering and Processing: Process Intensification, 47(2): 192-199.

Netafim Company. 2014. Hydrocyclone sand separators. Technical report. (Available from http://www.netafimusa.com/files/literature/agriculture/filters/hydrman-hydrocyclone-manual.pdf).

Ozyonar F. 2016. Optimization of operational parameters of electrocoagulation process for real textile wastewater treatment using Taguchi experimental design method. Desalination and Water Treatment, 57(6): 2389–2399.

Roy R.K. 2001. Design of experiments using the Taguchi approach: 16 steps to product and process improvement. John Wiley & Sons. New York.

Silva M.B., Carneiro L.M., Silva J.P.A., dos Santos Oliveira I., Izario Filho H.J. and de Oliveira Almeida C.R. 2014. An Application of the Taguchi Method (Robust Design) to Environmental Engineering: Evaluating Advanced Oxidative Processes in Polyester-Resin Wastewater Treatment. American Journal of Analytical Chemistry, 5: 828-837.

Silva A.C., Silva E.M.S. and Matos J.D.V. 2012. A modification in Plitt´s for hydrocyclones simulation. International Journal of Research and Reviews in Applied Sciences, 13(3): 753-758.